Thursday, February 15, 2007

Backup Sensor

Back Up Sensor Reverse Back Up Parking Warning Sensor Alarm with Surface, Flush and/or Bracket Mount Sensors. These are all complete system, nothing else is required. Depending on models, these sensors consist of two or four pre-wired ultra-sonic sensors, installed with double-sided tape (already attached on first model), or drilling holes into rear bumper is required for the rest of the models. backup sensor

A mini-speaker is located inside the vehicle, usually on the rear parcel shelf or the rear pillar on a wagon or SUV. Simple connections are required, one wire to a back up light wire and another to a good ground. Every other connection is a plug-in. backup sensor




HOW IT WORKS:When you put the vehicle in reverse, the unit emits two "beeps" to indicate that it is in operation. Then as you get closer to an object, the beeping increases in frequency and then becomes steady to indicate that you should stop backing. backup sensor



These units are intended to supplement your use of mirrors and turning of your head when backing up. Drive carefully! Great for cars, vans, trucks and RVs with plastic bumpers.
NOTE: The reversing aid is strictly a drive assist device. It should not be considered to be a safety device for any purpose.

It is not a substitute for driver responsibility when operating a vehicle. Please follow all local and federal laws when backing up your vehicle. The manufacturer and the distributor of these reversing aids do not guarantee or assume liability for "collision or damages" that take place when backing your vehicle. Use your mirrors, turn around and use all of the proper precautions to safely back your vehicle.

No comments: